Installation and Operation Guide SOLECTRIA XGI 1500 (Rev A, April 2019)
35 of 77
Inverter List
5.5
The Inverter List shows a register of all the inverters linked to the same Wi-Fi network to which the laptop or
smart device is connected. These inverters are said to comprise a cluster. Each XGI cluster consists of a
maximum of 50 or 100 inverters depending upon connection type (see Section 5.2.). The Inverter List will be
the screen that shows, once connected to “xgi.solar”.
The Inverter List displays the names, serial numbers, IP addresses, and status of the inverters, or nodes,
registered to the cluster. Below is an example Inverter List and a chart that explains the symbols. Note that the
node at the top in blue text is the node the user last accessed.
To navigate to a particular inverter, select the node name
of the inverter by clicking it.
In the example inverter list in Figure 5-7, several nodes
are worth noting:
Inverter 1: This node, indicated in bold, is the inverter
last accessed by the user. All other nodes communicate
through it.
Inverter 2: This node is an inverter that is operating
normally, indicated by the green checkmark.
Inverter 1 and Inverter 3: These nodes have an inverter
warning but are still producing power.
Figure 5-7 Inverter List Example
Table 5-2 Explanation of Symbols in User Interface
Inverter OK: This indicates that the inverter is functioning normally.
Inverter Missing: This indicates that the inverter registered as part of the network is
undetected.
Inverter Unknown: This indicates that the inverter detected was not registered as part of the
network.
Inverter Fault: This indicates that the inverter has an inverter issue that prevents it from
producing power.
Inverter Warning: This indicates that the inverter has an inverter issue that does not prevent
it from producing power.
Troubleshooting inverters is covered in Section 7 Maintenance and Troubleshooting.
To Next Page
Loading...
