Installation and Operation Guide SOLECTRIA XGI 1500 (Rev A, April 2019)
28 of 77
Antenna Mounting
3.11
Mount the antenna as shown in Figure 3-22. The antenna works best when oriented vertically.
Figure 3-20 Mounting the Antenna
Replace Wiring Box Cover
3.12
Replace Plastic Shield
Put the plastic shield back in place. Use a #2 Phillips head torque driver to tighten the screws to 20 in-lbs (2.3
N-m). Refer to Figure 3-7
Replace Cover
Put the cover back on the inverter. Use a #3 Phillips head torque driver to tighten the cover screws to 40 in-lbs
(4.5 N-m). Refer to Figure 3-6
Torque to Specified Value
Overtightening the screws may warp the cover or strip the screws.
To Next Page
Loading...
