Note: Set “1” when Stored Lead Screw Error
Compensation or Stored Stroke Limit is
provided, set ZZRNILKat 1, XZRNILKat 1.
n
#6007
D? D6
D4 D3 Dz DI
Do
EDTSTLK
D7
1: Does not cause an alarm upon Cycle Start
without reset operation after part program
edit operation.
0: Causes an alarm 005.
STUD D,
1: Effective on Cycle Start when cycle start
signal “1” changes to “O.”
O: Effective on Cycle Start when cycle start
signal “O” changes to “1.”
RliDOUTD4
1: Provides Rewinding Activate Signal when
NCprogram is rewound by
RESET& REWIND
signal.
O: Provides no Rewinding Activate Signal when
when NCprogram is rewound by RESET&
REWINDsignal.
OUTPUTDa
1: Sets the least output increment at 0.0001
inch.
1: Sets the least output increment at 0.001 mm.
SCHSOVDZ
1: Makes the Spindle Override 100%during
tapping.
O: Does not make the Spindle Override 100%
during tapping.
SLT310 D,
~: Establishes the prohibi ted area of the
Stored Stroke Limit 3 outside the boundary.
O: Establishes the prohibited area of the
Stored Stroke Limit 3 inside the boundary.
SLT210D,
1: Establishes the prohibited area of the
Stored Stroke Limit 2 outside the boundary.
O: Establishes the prohibited area of the
Stored Stroke Limit 2 inside the boundary.
El “
#6008
D.
D, DO
PONI197Ds
1: t197command (calculation of intersection)
is selected at power-on.
O: t196 command (circular arc) is selected at
power-on.
CVSAVEDi
1: Does not clear user macro commandvariable
#100 thru #149 by reset.
O: Clears user macro commonvariables #100
thru #140 by reset operation.
ZRNOFS
Do
1: Cancels the commandedblock when the second
reference point tJy G30 is commandedduring
Tool Position Offset or Tool Nose Radius
Compensation.
O: Cancels the blocks following the commanded
block.
m 3D6
‘5 ‘4 ‘3 ‘1 ‘o
ZIIOVILKD7
1: After turning on power, if move command
except by G28 is executed without returning
Z-axis to reference point manually or auto-
matically, alarm “001” will be caused.
O: Does not cause alarm in the same condition
shown above.
–113–
To Next Page
Loading...
