YASKAWA yasnac lx3 - Operating Procedure to Displayinput;Output S Ignals

4.6.2 OPERATINGPROCEDURETO DISPLAYINPUT/
When the cursor reaches top line, the screen
OUTPUTSIGNALS
switches to the previous page.
1. Depress the (DGN)key.
o
PAGE -
5. Depress the ~ key.
The next page will be displi
A page containing the diagnostic number speci-
1
t
fied previously will appear on the CRTscreen,
6. Depress the
PAGE key.
with the status of 1/0 signals displayed “l,”
The previous page will bed
‘O” and hexadecimal digits.
2. Key-in the diagnostic number to redisplay-
ed, and depress the CURSOR~or~key.
This will change the screen to the page
containing keyed-in number.
The data on each line is displayed in hexa-
decimal digits in the rightmost positions on
the screen.
HEXADECIMAL
NOTATION
f
I
\
DIAGNOSIS
2
01234 NO018
76543210
~looo 1 01 1 1 01 0
BA
d 1001
0000000000
t 1002
0 1 0 00 00 1
41
# 1003
00 0 1 1 00 0
18
# 1004 000 00 0 0 1
01
?$1005
1 1 01 000 1
D1
i 1006
01 01 01 1 0
56
# 1007
00010001
11
# 1008 01 01 0 1 00
54
flow 00 1 0 0 000
20
clOPEN
l:CLOSE
RDY
Fig. 4.1(I Example of Input/Output
Signal Display
n
CURSOR
3, Press the ~
key.
I
4
The cursor will move down by 1 line to the
next diagnostic number. Keeping this key de-
pressed continuously moves down the cursor.
When the cursor reaches the last lower line,
the screen switches to the next page.
T---T-l
4“ ‘ress ‘he CUR’SOR‘ey”
yed.
splayed,
L.~
The cursor will move up by 1 line to the pre-
.
vious diagnostic number. Keeping this key de-
pressed continuously moves up the cursor.
-49-