4.3.10 OPERATIONIS NOTAVAILABLEWITIIGO1, G02 or 03.
Trouble
Spindle stops at feed
per revolution.
Spindle revolution is
checked by feed per
minute.
Cutting feed override
is set to O%.
Manual jog feedrate is
nt;t set correctly at
dry run status.
Interlock signal is
entered.
——
Servo system is erro-
neously set.
Check Procedure
;heck on~ylscreen if the mode is S(
to G!19.
;heck ifmti6006 Dq is at 1 (spinal
revolution is checked if it is at 1)
;AGR#1306 117
Insure if~#1301 DOto Dq is set
:orrectlyo
~~edoverride/~anua1JOGfeedrate Selection
Check if~]i!1305 Ds is at 1 (norms
it is O).
Check if manual spindle feed is work
(check its function by manual mode).
Solution
~urn the spindle. Make
;ure of revolution by~
;pindle revolution display.
(Spindle PG monitor~l~
——
41287
D4, D5)
hrn the spindle.
[f it is at dry run, make
spindle revolution nclt be
:hecked by setting #fiO06
)4=0,
I’urn the override switch.
;orrect wiring if discon-
~ected.
;heck parameter setting.
Release interlock with
reference to instruction.
Manual of machine manufac-
turer. Refer to the item
for manual feed.
–36-
To Next Page
Loading...
