Yealink SIP-T2XP - Page 48

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
32
network as a stand-alone device with its own IP address.
 Router: The IP phone functions as a router, and provides a DHCP service for the
connected PC.
If the PC port is unused, it can be disabled via web user interface or using configuration
files.
Note
Procedure
PC port mode can be configured using the configuration files or locally.
Configuration File
<y0000000000xx>.cfg
Configure the PC port mode.
Disable the PC port.
For more information, refer to PC
Port Mode on page 276.
Local
Web User Interface
Configure the PC port mode.
Disable the PC port.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network-pcport&q=load
Phone User Interface
Configure the PC port mode.
To configure the PC port mode via web user interface:
1. Click on Network->PC Port.
2. Select the desired value from the pull-down list of PC Port Active.
3. Mark the desired radio box.
If you mark the As Router radio box, you can configure the IP address for the PC port
and configure DHCP for the PC attached to the PC port.
1) Enter the IP address in the IP Address field.
2) Enter subnet mask in the Subnet Mask field.
3) Select the desired value from the pull-down list of Enable DHCP Server.
4) Enter the start IP address in the Start IP Address field.
The router mode is not applicable to SIP-T19P and SIP-T21P IP phones.