Yealink SIP-T31G Administrator's Guide

Call Features
382
acters when dialing.
Example:
features.call_num_filter = -
If you dial 3-61, the phone will filter the character - and then dial out 361.
Note: If it is left blank, the phone will not automatically filter any characters when dialing.
Permitted
Values
String within 99 characters
Default
, -()
Web UI
Features > General Information > Call Number Filter
IP Address Call
You can set the phone whether to receive or place an IP call. You can neither receive nor place an IP call if you dis-
able this feature.
Topic
IP Address Call Configuration
IP Address Call Configuration
The following table lists the parameter you can use to configure IP address call.
Parameter
features.direct_ip_call_enable <y0000000000xx>.cfg
Description
It enables or disables to allow IP address call.
Note: If you want to receive an IP address call, make sure “sip.trust_ctrl” is set to 0 (Disabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Web UI
Features > General Information > Allow IP Call
Ignoring Incoming Calls
By default, when a phone receives an incoming call, the phone screen prompts the incoming call information. You
should handle the incoming call first before performing other features. For example, you should handle the incom-
ing call when there is an active call in progress, otherwise, you cannot hold or set up a conference on the current
call.
You can configure the phone to ignore an incoming call. The incoming call is still in the progress and is not rejec-
ted, you can choose to answer it or not, or perform other features.
When the phone receives an incoming call in the idle state, the screen prompts the incoming call information.
l To ignore the call, and initial a new call, pick up the handset, press the Speakerphone key or HEADSET key,
press keypad or other line keys.
l
To answer the incoming call, press the corresponding line key, the Answer soft key or the OK key.
When the phone receives an incoming call in the call state, the screen does not prompt the incoming call inform-
ation. You can perform other features on the current call. You can only answer the incoming call after ending the cur-
rent call.

Yealink SIP-T31G Specifications

General

Mounting kit	Yes
Number of handles included	1 pc(s)
Display diagonal	2.3 \
Display resolution	132 x 64 pixels
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Voice codecs	G.722, G.729, AGC, G.729A, AJB, PLC, G.711Mu, VAD, G.711a, G.723.1, G.726, iLBC, CNG, OPUS
AC adapter input voltage	100 - 240 V
AC adapter output current	0.6 A
AC adapter output voltage	5 V
Power consumption (typical)	3 W
Lines quantity	2 lines
Phonebook capacity	1000 entries
Number of VoIP accounts	2
Sustainability certificates	RoHS, REACH
Networking standards	IEEE 802.3af, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1x
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	189 mm
Width	188 mm
Height	162 mm
Package depth	210 mm
Package width	213 mm
Package height	103 mm