Registering a repeater
The repeater can register to the base station in two ways:
Auto Registration
Manual Registration
Note: The “Repeater Mode” must be enabled on the base station. In order to do that, go to Main Menu
Settings System Settings Repeater Mode Change
Auto Registration
To register a repeater automatically:
Switch on the repeater and check if the LED indicator on the repeater double flashes. If the LED
indicator does not double flash, you need to de-register the repeater first. Please refer to “De-
registration”. If the LED indicator double flashes, go to next step .
Switch off the repeater (disconnect the power adapter).
Set the base station in registration mode. Long press the paging key on the base station till the first
LED flashes.
Switch on the repeater (connect the power adapter).
The LED indicator on the repeater flashes. After a short while, the LED indicator stays on
permanently indicating that registration is completed, and the repeater is ready for use. The first LED
on the base station flashes after the registration is completed. You can press the paging key to
cancel the flash.
Note: If the registration is not successful, the LED indicator will flash continuously. In this case, repeat steps
from Switch off Repeater.