Yealink W52P Full User Guide

© Gamma 2014. All rights reserved. Confidential.
Manual Registration
The repeater, base station and handset must be accessible before performing the registration. If you want
to register more than one repeater, the registration must be performed separately for each repeater.
To register a repeater manually:
 Set the repeater in registration mode.
 Switch on the repeater for 1-5 seconds and then switch it off. Switch it on once more and leave it
there.
The LED indicator on the repeater flashes slowly. You now have five minutes to complete the registration.
If the registration is not completed within this period, you must start over again.
 Set the base station in registration mode.
 Long press the paging key on the base station till the first LED flashes.
 The LED indicator on the repeater flashes.
If the LED flashes fast without interruptions, go to Assign a repeater number. If the LED flashes fast with
interruptions, go to Registration of handset.
 Registration of handset.
You must re-register the handset even if the handset used was already registered to the base station. Now
the LED indicator flashes fast without interruptions.
 Assign a repeater number.
You must now assign a repeater number to the repeater (choose from 2 to 7, for up to 6 repeaters):
 Press #*9 and the off-hook key on the handset. The LED indicator illuminates.
 Press a number between 2 and 7. When the repeater has accepted the chosen number, the LED
indicator will flash a corresponding number of times. If you miss the confirmation flash, press the
number again.
 Accept the registration by pressing the * key, and then press the on-hook key. The repeater is now
automatically restarted: the LED indicator goes off for 2 seconds, flashes for a brief moment and
then stays illuminated. The registration of the repeater is completed. You can now disconnect the
power adapter and move the repeater to the selected location (disconnecting the power will not clear
the registration).
Note: Each number can be assigned only once when using more than one repeaters on a base station.
Repeater number and handset number are independent of each other.

Yealink W52P Specifications

General

Caller ID	Yes
Lines quantity	- lines
Answering machine	No
Phonebook capacity	500 entries
Handset type	Wireless handset
Product type	IP Phone
Product color	Black
Maximum indoor range	50 m
Maximum outdoor range	300 m
Voice codecs	G.711, G.723, G.726, iLBC
Number of melodies	9
Display diagonal	1.8 \
Display resolution	128 x 160 pixels
Headset connectivity	2.5 mm
Ethernet LAN (RJ-45) ports	1
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Standby time	100 h
Number of handles included	1 pc(s)
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	108 mm
Width	153 mm
Height	45 mm
Height (max)	50 mm
Height (min)	144 mm