Yeastar Technology S-Series Administrator's Guide

S-Series IP PBX Administrator Guide
88
Figure 9-5 Codec Settings
TLS
Yeastar S-Series supports TLS protocol, to use TLS, you need enable TLS via Settings > PBX >
General > SIP > TLS. Check the TLS configuration parameters below.
Table 9-8 TLS Configuration Parameters
Option
Description
Enable TLS
Check the checkbox to enable TLS.
TLS Port
TLS Port used for SIP registrations. The default is 5061.
Certificate
Choose the TLS certificates.
TLS Verify Server
If set to no, don't verify the servers certificate when acting
as a client. If you don't have the server's CA certificate
you can set this and it will connect without requiring TLS
CA file. The default is no.
TLS Verify Client
If set to yes, verify certificate when acting as server. The
default is no.
TLS Ignore Common Name
If set to yes, verify certificate when acting as server. The
default is no.
TLS Client Method
Specify protocol for outbound client connections. The
default is sslv2.
Session Timer
A periodic refreshing of a SIP session that allows both the user agent and proxy to determine if the
SIP session is still active.
Table 9-9 Session Timer Configuration Parameters
Option
Description
Session-timers
Choose the session timers mode on the system:
 No: do not include “timer” value in any field
 Supported: include “timer” value in Supported header

Yeastar Technology S-Series Specifications

General

Brand	Yeastar Technology
Model	S-Series
Category	PBX
Language	English