YOKOGAWA BT200

<Toc> <Ind> <4. BT200 BASIC OPERATIONS >
4-11
IM 01C00A11-01E
K10   ESC
F0415-2.EPS
PARAM
K10:OUTPUT X %
 0.0 %
K60:SELF CHECK
 GOOD
 A10  ESC
PARAM
A10:OUTPUT
100.0 %
A11:ENGR. OUTPUT
1000 mmH2O
A20:AMP TEMP
23°C
esc
 While commands are
displayed on panel , type
the number of a parameter to
be displayed and press [ENT]
to call the parameter panel for
the entered number.


 Example: Call the parameter
panel ‘K10: OUTPUT X%’
from panel .




 ➝Type ‘K10’ and press [ENT].
[F2] A10
[F4] ESC
➝Panel
➝Returns the function
commands to
commands shown
on panel .
3
䊊
1
䊊
Number of the starting parameter on
the panel before the last
Number of the starting parameter on the
previous panel
3
䊊
3
䊊
3
䊊
4
䊊
c) Call the self-check panel
Press [F2] DIAG on a parameter panel to call a self-
check panel. The self-check panel displays self-
check information on the connected instrument. This
function is not available for signal conditioners.
PARAM
A10:OUTPUT
100.0 %
A11:ENGR. OUTPUT
1000 mmH2O
A20:AMP TEMP
23°C
DATA DIAG PRNT ESC
F0416.EPS
DIAG
C60:SELF CHECK
 GOOD
FEED  PRNT ESC
DIAG
C60:SELF CHECK
 ERROR
< ERROR >
< OUT OF RANGE >
< OVER SENS TEMP >
< OVER OUTPUT >
FEED  PRNT ESC
FEED
PRNT
ESC
Paper feed
Print (See Section 5.2(6).)
Returns to parameter panel
(When errors occer)