3. Cabling
3-72
TI 33Q01J10-01E
Connecting Signal Cables with MCM Terminal Board
Two AMC80s can be set up in a dual-redundant configuration by connecting them to an MCM
terminal board as shown in the figure below.
When the AMC80 is used in a single configuration, one MCM terminal board is required for each
AMC80.
Do not set up AMC80s in the single mode when they are connected to a MCM terminal board in
the dual-redundant configuration.
RDY
DX
OUT
YOKOGAWA YOKOGAWA
RDY
DX
OUT
F030710.ai
KS1 Cable
AMC80
MCM Terminal Board
To other converter
××
×
×
×
××
×
×
×
××
×
×
×
××
×
×
×
××
×
×
×
××
×
×
×
××
×
×
×
××
×
×
×
Figure Example of Dual-redundant AMC80 Configuration
Sep. 30, 2008-00
To Next Page
Loading...
