YOKOGAWA CENTUM CS 3000 - Connecting Signal Cables with Multiplexer Modules (Connector Type)

3. Cabling
3-75
TI 33Q01J10-01E
3.7.7 Connecting Signal Cables with Multiplexer Modules
(Connector Type)
Multiplexer Modules (Connector Type) AMM12C, AMM22C, AMM25C,
AMM32C, AMM32CJ
Connect the shield of the Yokogawa-specific cable to each screw-mount shield terminal.
1 2 3 4
F030715.ai
AMN32
Shield
Connector
Connector
Shield
Screw-mount terminals
Multiplexer Module
(Connector Type)
Figure Multiplexer Module (Connector Type) Signal Cable Connection
Connector Type Multiplexer Module and Terminal Board/Terminal
Block
Connect a multiplexer module to a terminal board/terminal block as described in the table below.
Table Connecting a Multiplexer Module and Terminal Board/Terminal Block
Multiplexer Module
(Connector Type)
Terminal Board Terminal Block Cable
AMM12C MUB TE16 KS2
AMM22C MUB TE16 KS2
AMM25C MTC TETC KS1
AMM32C, AMM32CJ MRT TERT KS8
May 18, 2007-00