Setting the Measurement Mode
Setting the Measurement Mode
The measurement mode determines how the entire
GX/GP system operates. The GX/GP measurement
characteristics change depending on the measurement
mode. The measurement mode must be set before
reconfiguration and before specifying various settings.
By factory default, the measurement mode is set to
Normal. When performing high-speed or dual interval
measurement according to measurement conditions, you
need to set the measurement mode to High speed or Dual
interval.
1
Press MENU.
2
Tap the Browse tab.
3
Tap Initialize Calibration.
4
Tap Measuremet mode.
5
Setting the Measurement Mode.
6
Tap Execute.
A conrmation screen is displayed.
7
Tap OK
Operation complete
Note
• When the measurement mode is changed, the system
restarts, and the following data is initialized. Set the
measurement mode before reconfiguration and before
specifying various settings.
Data subject to initialization
All internal data
All setting parameters including security settings but
excluding communication settings
System configuration data
• You cannot set the measurement mode when
recording, computation, or control execution is in
progress.
• The measurement mode is not initialized during
initialization.
• If the advanced security function (/AS) or multi-batch
function (/BT) is enabled (On), the measurement
mode is fixed to Normal.
When changing the measurement mode, disable the
functions beforehand.
Limitations
Depending on the measurement mode, there is a limit
to the number of measurement channels, the number of
recording channels, and the supported modules.
For the specific limitations, see the limitations provided in
the following general specifications.
• GX/10/GX20 Paperless Recorder (panel mount type)
General Specifications GS 04L51B01-01EN
• GP10/GP20 Paperless Recorder (portable type)
General Specifications GS 04L52B01-01EN
This section explains the measurement mode, which needs to be set properly according to the measurement conditions.
To Next Page
Loading...
