YOKOGAWA RAMC - 11 Instructions for PED

<11. INSTRUCTIONS FOR PED>
11-1
IM 01R01B02-00E-E 12th edition October 01, 2014 -00
All Rights Reserved. Copyright © 2003, Rota Yokogawa
11. Instructions for PED
The units are produced according the determinations of directive 97/23/EG (directive for Pressure – Equipment / PED ).
The units are classied as pipe according item 3, number 1, 3. letter, a) rst dash or according diagram 6 after
appendix II :
- Classication as pipe
- For Fluid Group 1 and 2 (article 9 chapter (2)). For uid group 2 with a max. partial pressure of 1.5 bar at T
max.
- Medium uid and gas
The basic safety requests (for design, production and testing) for all units according to category I to III are
generally determined for the requests of category III.
The units, which are not excluded by PED article 3 paragraph 3, are checked by a conformity-valuation-method
according appendix III ´module H´.
The complete quality assurance system according PED appendix III module H was certied by the notied body :
Lloyd's Register Verication Limited, 71 Fenchurch Street London EC3M 4BS UK
ID-No. 0038
The user is responsible for the use of our owmeters regarding suitability and use as agreed.
PED-Data on RAMC
F110.EPS
0038
RY
IMPORTANT