YOKOGAWA UT320 Instruction Manual

<Toc> <4. Troubleshooting and Maintenance>
4-9
IM 05D01D02-41E
7.
Insert the internal unit into the housing.
Apply power to the controller and confirm that the initial operating display is shown.
If the operating display is not shown properly, turn off the controller and pull out the
internal unit. Then, insert it into the housing again.
This completes replacement of the control output relay.
1st Edition : May 31,2000-00

YOKOGAWA UT320 Specifications

General

Brand	YOKOGAWA
Model	UT320
Category	Controller
Language	English