S-11
IM 760401-01E
Startup Guide
Turning ON the Power to the Circuit under Measurement
Check the following items before turning on the power to the circuit under measurement.
• The power supply of the WT230 is connected.
• Input terminal screws are securely fastened.
• The current input protection covers are attached.
• The power to the WT230 is ON and it is ready to make measurements.
7.
Turn ON the power to the circuit under measurement.
8.
Operate the inverter to rotate the motor.
Selecting the Measurement Range
To Next Page
Loading...
Need help?
General
