EasyManuals Logo

YOKOGAWA WT210 User Manual

YOKOGAWA WT210
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #309 background imageLoading...
Page #309 background image
16-14 IM 760401-01E
Item Specifications
Safety standard
*1
Complying standard EN61010-1
Installation category (overvoltage category) CAT II
*2
Measurement Category CAT II
*6
Pollution degree 2
*3
Emission
*1
Complying standard EN61326 Class A
EN61000-3-2
EN61000-3-3
AS/NZS 2064 Class A
This product is a Class A (for industrial environment) product. Operation of
this product in a residential area may cause radio interference in which case
the user is required to correct the interference.
Cable condition • Serial (RS-232-C) interface connector
Use shielded serial cables
*4
.
• GP-IB interface connector
Use shielded GP-IB cables
*4
.
• D/A output terminal
Use shielded cables
*4
.
• Connecting cables may cause radio interference in which case the user
is required to correct the interference.
Immunity
*1
Complying standard EN61326 Annex A
*5
However, the measured values may receive noise effects.
Cable condition Same as the cable condition for emission above.
*1 Applies to products with CE marks. For all other products, contact your nearest YOKOGAWA dealer.
*2 The Overvoltage Category is a value used to define the transient overvoltage condition and includes the impulse withstand
voltage regulation. Overvoltage Category II: Applies to equipment supplied with electricity from fixed installations like a
distribution board.
*3 Pollution Degree: Applies to the degree of adhesion of a solid, liquid, or gas which deteriorates withstand voltage or surface
resistivity. Pollution Degree 1: Applies to closed atmospheres (with no, or only dry, non-conductive pollution). Pollution
Degree 2: Applies to normal indoor atmospheres (with only non-conductive pollution).
*4 Use cables of length 3 m or less.
*5 Annex A (specifications): Immunity test requirement for equipment used in industrial environment.
*6 Measurement Category II (CAT II) applies to electrical equipment that is powered through a fixed installation such as a wall
outlet wired to a distribution board and measurement performed on such wiring.
16.10 General Specifications

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the YOKOGAWA WT210 and is the answer not in the manual?

YOKOGAWA WT210 Specifications

General IconGeneral
BrandYOKOGAWA
ModelWT210
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals