EasyManua.ls Logo

YooFab RFLEGO - Verifying Toroid Winding Quality

Default Icon
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Toroid winding step 23
Optionally, we can measure the value of one of these windings using an LC meter.
Note that this toroid will show different results than our black FT37-43 which is
wound with 33SWG solderable enamelled copper wire.
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
Copyright © 2018 - 2019 www.yoofab.com G.D.COWNE - MØOOZ page 54 of 66