Step 13
• Fit the stand-off posts to the board.
• The black plastic posts are fitted to the copper side of the board, whereas the
small plastic screws are fitted to the DECAL side of the board.
• Tighten the screws but do not over-tighten them, as this will damage the thread
on the screw.
Congratulations!
Congratulations, you have now completed the kit.
ASSEMBLY INSTRUCTIONS
RFLEGO Active Antenna Receiving Loop
Copyright © 2018 - 2019 www.yoofab.com G.D.COWNE - MØOOZ page 66 of 66
To Previous Page
Loading...