Need help?Do you have a question about the YooFab RFLEGO and is the answer not in the manual?
Emphasizes that the antenna is receive-only and must not be used for transmitting.
Details immunity to QRM, stealth operation, broad HF band capability, and compact design.
Presents the schematic of the RFLEGO Active Antenna Receiving Loop.
Describes how RF signals are processed by the differential amplifier.
Explains the common base differential amplifier, biasing, and input impedance.
Details the transformer's role in converting balanced to unbalanced output.
Specifies the 2.1mm DC power jack and clean supply requirement.
Details the RCA socket for connecting to receivers and potential adaptors.
Describes the two banana sockets for attaching the antenna loop wire.
Defines what an electronic kit typically consists of.
Highlights ease of build, hands-on experience, and quality documentation.
Outlines crucial steps like reading instructions, preparing workspace, and checks.
Discusses the hand-produced PCB, vinyl protection, and optional lacquer.
Instructions for correctly applying the decal sticker to the PCB.
Explains compatibility between RFLEGO modules and standard connectors.
Defines RFLEGO as a modular, educational, and functional system.
Provides detailed guidance on soldering SMDs, including iron temperature and solder.
Covers cutting excess leads and inspecting soldered joints for quality.
Details how to inspect the printed circuit board before starting assembly.
Guides for soldering resistors R1 through R9 across multiple steps.
Guides for soldering capacitors C1 through C8 across multiple steps.
Step 8: Solder the two NPN transistors Q1 and Q2, noting lead bending.
Step-by-step guide to twisting and preparing the two-strand wire for winding.
Detailed process for winding the bifilar transformer onto the toroid.
Instructions for measuring inductance and impedance of the toroid windings.
Explains the process of soldering the wound transformer to the circuit board.
Guidance on identifying winding polarity for correct magnetic sense.
Specifies the exact locations on the PCB for soldering the toroid leads.
Steps for fitting the two banana sockets for antenna loop input.
Instructions for mounting the RCA connector for RF output.
Guides on fitting the 2.1mm power jack socket.
Details soldering of wires to banana posts and other final connections.
Steps for fitting and soldering the 5mm LED indicator.
Instructions for attaching the plastic stand-off posts to the board.
To Next Page
General