EasyManuals Logo

Zapi ACE3 User Manual

Zapi ACE3
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
Page – 56/139 AFFZP0BB – ACE3 – User Manual
ADJUSTMENT
Parameter Allowable range Description
CHECK UP TYPE
(T, TM, P, CO)
NONE ÷ OPTION#3 This parameter defines the CHECK UP NEEDED warning:
NONE = no CHECK UP NEEDED warning.
OPTION#1 = CHECK UP NEEDED warning shown on the
hand-set and MDI after 300 hours.
OPTION#2 = like OPTION#1, plus speed reduction
intervenes after 340 hours.
OPTION#3 = like OPTION#2, plus the truck definitively
stops after 380 hours.
PWM EV1
(A – Premium only)
0% ÷ 100%
(255 steps)
This parameter defines the duty-cycle of the PWM applied to
EV1 output (B16).
PWM EV2
(A – Premium only)
0% ÷ 100%
(255 steps)
This parameter defines the duty-cycle of the PWM applied to
EV2 output (B17).
PWM EV3
(A – Premium only)
0% ÷ 100%
(255 steps)
This parameter defines the duty-cycle of the PWM applied to
EV3 output (B18).
PWM EV4
(A – Premium only)
0% ÷ 100%
(255 steps)
This parameter defines the duty-cycle of the PWM applied to
EV4 output (B19).
PWM EV5
(A – Premium only)
0% ÷ 100%
(255 steps)
This parameter defines the duty-cycle of the PWM applied to
EV5 output (B9).
MC VOLTAGE
(A)
0% ÷ 100%
(by 1% steps)
This parameter specifies the duty-cycle (t
ON
/T
PWM
) of the PWM
applied to the main-contactor output (A16) during the first
second after the activation signal that causes the main
contactor to close.
MC VOLTAGE RED.
(A)
0% ÷ 100%
(by 1% steps)
This parameter defines a percentage of MC VOLTAGE
parameter and it determines the duty-cycle applied after the
first second of activation of the contactor.
Example 1
MC VOLTAGE = 100%
MC VOLTAGE RED = 70%
The contactor is closed by applying 100% PWM to the coil
for one second, then duty-cycle is reduced to 70%.
Example 2
MC VOLTAGE = 70%
MC VOLTAGE RED. = 100%
The contactor is closed by applying 70% PWM to the coil
for one second, then duty-cycle is kept at the same value.
Example 3
MC VOLTAGE = 70%
MC VOLTAGE RED = 70%
The contactor is closed by applying 70% PWM to the coil
for one second, then duty-cycle is reduced to 49%.
EB VOLTAGE
(A)
0% ÷ 100%
(by 1% steps)
This parameter specifies the duty-cycle (t
ON
/T
PWM
) of the PWM
applied to the main-contactor output (A18) during the first
second after the activation signal that causes the
electromechanical brake to release.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zapi ACE3 and is the answer not in the manual?

Zapi ACE3 Specifications

General IconGeneral
BrandZapi
ModelACE3
CategoryInverter
LanguageEnglish

Related product manuals