Zebra 105Se - Index

115 VAC Operation .....................2-3
12-Dot/mm and 6-Dot/mm Printhead........9-4
230 VAC Operation .....................2-3
230 VAC Power Cord ...................A-1
A
Additional System Requirements ...........1-3
Adjustments
Bar Code Darkness..................C-1
Black Mark Media Sensor ............7-2
Lower Transmissive Media Sensor......7-4
Media and Ribbon Sensor Sensitivity....7-5
Printhead Pressure...................7-1
Upper Transmissive Media Sensor......7-3
ASCII Code Chart ......................B-1
ASCII Control Codes ....................5-3
B
Bar Code Darkness......................C-1
Baud Rate (Setting)......................4-2
Burn Temperature (Adjusting) .............4-6
C
Calibration ............................4-4
Label Top .........................4-6
Media Rest ........................4-6
Print Darkness......................4-6
CANCEL Key..........................3-4
CANCEL Key Self Test ..................3-9
Cleaning
Cutter Module......................6-3
Exterior Surfaces....................6-1
Interior ...........................6-1
Printhead and Platen Roller ...........6-2
Schedule ..........................6-1
Sensors ...........................6-3
Communications
Diagnostic Test ....................3-12
Communications Capabilities
Asynchronous Modems ..............1-1
Host Systems.......................1-1
Configuration Mode .....................4-4
Connection Recommendations
and Cautions ........................1-4
Cutter Mode Media Loading..............2-11
D
Damage Report .........................2-1
Darkness (Adjusting) ....................4-6
Data Bits (Setting) ......................4-2
Data Signal Levels ......................5-5
Data Terminal Ready (DTR) ..............5-3
DCE Devices...........................5-4
DTE Devices...........................5-4
DTR/DSR Data Flow Control (Setting) ......4-2
E
Electrical Noise .....................5-4, 5-5
Error Detection (Setting) .................4-2
Extended Printer Diagnostics .............3-13
F
Factory Defaults ........................4-4
Fanfold Media Loading .................2-11
FCC Rules and Regulations ...............1-4
FEED Key.............................3-4
FEED Key and CANCEL Key Self Test ....3-13
Zebra S-Series User’s Guide Index - 1
Index
101