Zebra 105Se - Technical and Maintenance Index

O
Operating Modes
Cutter ............................3-3
Peel-Off...........................3-3
Rewind ...........................3-3
Tear-Off ..........................3-2
Option Switches ........................4-1
Optional Printer Fonts ...................D-1
Options
230 VAC Factory Setup ..............9-3
Black Mark Sensor ..................9-2
Cutter Module......................9-1
Fanfold Media Bin ..................9-2
Fanfold Supply Bin..................9-2
Fonts .............................9-3
Media Rewind......................9-1
Memory...........................9-4
Peel-Off...........................9-1
Printheads .........................9-4
ZebraNet ..........................9-2
P
Parallel Cabling Requirements .............5-5
Parallel Interface........................5-5
Parity (Setting) .........................4-2
PAUSE Key ...........................3-4
PAUSE Key and CANCEL Key Self Test . . . 3-12
PAUSE Key Self Test...................3-10
Peel-Off Media Loading .................2-10
Power (AC)
115 Operation ......................2-3
230 Operation ......................2-3
Fuse Replacement...................2-3
Voltage Selection ...................2-2
Power On Self Test......................3-7
Precautions ............................1-4
Print Darkness (Adjusting) ................4-6
Print Mechanism........................1-2
Print Quality ...........................1-3
Reflectivity and Contrast .............1-3
Printer Operating Modes
Media Sensing......................3-1
Media Transport ....................3-2
Printer Power Up ......................2-14
Printer Self Tests
CANCEL Key......................3-9
Communications Diagnostics .........3-12
FEED Key........................3-11
FEED Key and CANCEL Key ........3-13
FEED Key and PAUSE Key..........3-12
Introduction to......................3-7
MODE Key.......................3-12
PAUSE Key ......................3-10
PAUSE Key and CANCEL Key.......3-12
Printer Specifications (Complete Listing) ....1-6
Printhead Life
Media Abrasion.....................1-3
Printhead Pressure Adjustment.............7-1
Printhead Wear (Guarding Against
Premature) ..........................1-3
Protocol Converter (When Required)........1-1
R
Removing Used Ribbon
105Se ...........................2-12
160S ............................2-13
Repacking the Printer
Caution Statements ..................1-5
Reporting Damage ......................2-1
Requirements
Media and Ribbon...................1-3
Reshipping ............................2-1
Rewind Mode Media Loading ............2-10
Ribbon
Lengths and Widths .................1-2
Zebra S-Series User’s Guide Index - 3
103