23
Introduction
Control Panel Display
7/3/13 P1056468-002
Set Supplies Low Warning
When this feature is enabled, the printer provides warnings when
the media or ribbon is reaching near the end of the roll.
See Supplies Low Warning on page 89 for more information.
Set Early Warning for Maintenance
When this feature is enabled, the printer provides warnings when
the printhead needs to be cleaned.
See Early Warning for Maintenance on page 89 for more
information.
Set Printhead Cleaning Interval*
When Early Warning for Maintenance is enabled, set this value to
the length of the media or ribbon roll that you are using.
See Printhead Cleaning Interval on page 89 for more information.
* This parameter appears only if Early Warning for Maintenance
is enabled.
Reset Printhead Cleaning Counter for Early Warning*
• If you received the message WARNING CLEAN PRINTHEAD,
clean the printhead, and then press PLUS to select
YES to reset
the Early Warning for Maintenance printhead cleaning counter.
• If you have not cleaned the printhead, press MINUS to select
NO.
* This parameter appears only if Early Warning for Maintenance
is enabled.
Set Printhead Life Expectancy*
When Early Warning for Maintenance is enabled, set this value to
the number of inches of media that the printhead is expected to
print.
See Printhead Life Expectancy on page 89 for more information.
* This parameter appears only if Early Warning for Maintenance
is enabled.
To Next Page
Loading...
Need help?
General
