Zebra 105SL Plus User Manual

Printer Configuration and Adjustment
Changing Printer Settings
84
P1056468-002 7/3/13
Tear-Off
Position
If necessary, adjust the position of the media over the tear-off bar after printing.
• Higher numbers move the media out (the tear line moves closer to the leading edge of
the next label).
• Lower numbers move the media in (the tear line moves closer to the edge of the label
just printed).
Accepted values:
–120 to 120
Related ZPL command(s):
~TA
SGD command used:
none
Control panel menu item: TEAR OFF on page 21
Printer web page:
View and Modify Printer Settings > General Setup >
Tear Off
Print Mode Select a print mode that is compatible with your printer options.
Accepted values:
• TEAR OFF—The printer prints label formats as it
receives them. The printer operator can tear off the
printed labels any time after they print.
• PEEL—The printer peels the label from the liner
during printing and then pauses until the label is
removed. The liner winds onto the rewind spindle.
• REWIND—The printer prints without pausing
between labels. The media is wound onto the rewind
spindle after printing.
• CUTTER—The printer prints a label and then cuts it
free.
Related ZPL command(s):
^MM
SGD command used:
media.printmode
Control panel menu item: PRINT MODE on page 21
Printer web page:
View and Modify Printer Settings > General Setup >
Print Mode
Table 7 • Print Settings (Continued)
1
2
1
Media direction
2
Factory-set tear line location at position 000

Zebra 105SL Plus Specifications

General

Weight	50 lbs / 22.7 kg
Humidity	20-85% non-condensing
Print Method	Thermal Transfer
Resolution	203 dpi (8 dots/mm)
Max Print Width	4.09 inches / 104 mm
Max Print Speed	12 inches per second / 305 mm per second
Memory	16 MB SDRAM, 8 MB Flash
Media Width	0.79 inches / 20 mm to 4.5 inches / 114 mm
Media Thickness	0.003 inches / 0.076 mm to 0.012 inches / 0.305 mm
Media Types	Continuous, die-cut, black mark
Ribbon Width	2.00 inches / 51 mm to 4.33 inches / 110 mm
Ribbon Length	1476'/450 m
Connectivity	Parallel, Serial
Optional Connectivity	Ethernet, Wireless
Power Requirements	90-264 VAC; 48-62 Hz
Operating Temperature	40°F to 105°F / 5°C to 40°C
Storage Temperature	-40°F to 140°F / -40°C to 60°C