Accessories
54
Figure 59 Insert Loop
2. Feed the other end of the tether through the loop.
Figure 60 Feed Tether Through Loop
3. Pull the tether all the way through the loop.
4. Insert the loop of the tether through the eyelet on the hand strap of the Expansion Back.
5. Feed the stylus through the loop.
Figure 61 Feed Stylus through Loop
6. Pull the stylus all the way through the loop.
7. Slide the stylus into the holder for storing the stylus.
Figure 62 Insert Stylus into Holder
Removal
To remove an Expansion Back:
To Next Page
Loading...
