Accessories
50
Figure 51 Secure Screws
5. Using a T6 Torx screwdriver, secure expansion back to device using four screws. Torque to 14 n-cm.
Replacement Hand Strap
To replace the hand strap:
1. If the Power Pack is installed, remove the Power Pack.
2. Rotate the disk so that the strap end without the eyelet is aligned with the Power Pack opening.
3. Open both ends of the hand strap.
Figure 52 Open Straps
4. Pull the strap end without the eyelet through the slot on the Expansion Back.
Screws (4)
To Next Page
Loading...
