Zebra G SERIES Service Manual

17
Troubleshooting
Status Light Error Resolutions
8/27/08 Thermal Transfer G-Series
TM
Service Manual 980618-001 A
The printhead needs to cool down.
• If this error continues, turn the printer power off for five minutes or more, and then turn
on. If the amber light persists, then the printer requires service.
4. The printer is receiving data.
• As soon as all of the data has been received, the status LED will turn green and the printer
will automatically resume operation.
5. The media is out.
• Follow the instructions for Loading Media in users manual, and then press the Feed button
to resume printing.
The ribbon is out.
• The printer has sensed the end of the ribbon roll. Replace the ribbon.
The printhead is open.
• Close the top cover and then press the Feed button to resume printing.
6. The printer is paused.
• Press the Feed button to resume printing.
7. The printhead is over temperature.
• Printing will stop until the printhead cools to an acceptable printing temperature. When it
does, the printer will automatically resume operation.
8. FLASH memory is not programmed.
• Return the printer to an authorized reseller.
9. The printhead or motor has had a critical failure.
• Return the printer to an authorized reseller.

Zebra G SERIES Specifications

General

Print Method	Thermal Transfer
Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Maximum Print Length	39 inches (991 mm)
Media Sensors	Reflective, Transmissive
Media Length	39"/991 mm
Programming Languages	ZPL II
Connectivity	USB, Serial, Parallel, Ethernet (depending on model)