Zebra G SERIES Service Manual

8/27/08 Thermal Transfer G-Series
TM
Service Manual 980618-001 A
5
Replacing Parts
In the event you must replace a spare part, review the repair path decision tree to see which
procedures to perform. Read the steps in the required procedures to remove the old part and
install the new part. Other required procedures may include cleaning or other maintenance
after the spare is replaced.

Zebra G SERIES Specifications

General

Print Method	Thermal Transfer
Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Maximum Print Length	39 inches (991 mm)
Media Sensors	Reflective, Transmissive
Media Length	39"/991 mm
Programming Languages	ZPL II
Connectivity	USB, Serial, Parallel, Ethernet (depending on model)