Zebra G SERIES Service Manual

49
Replacing Parts
Replacing the Bottom Case and Back Panel
8/27/08 Thermal Transfer G-Series
TM
Service Manual 980618-001 A
Installation
1. From beneath, lower bottom case from the front to the rear of the printer.
2. Place the five screws back into their places and tighten with screwdriver.
3. For printers with the cutter option, replace the cutter bezel. The cutter’s mounting bracket
slides inside of the lip located on top of the inside of the cutter bezel. Swing the bezel over
the cutter bracket and secure it with the two screws.
4. From the rear, align the back panel to the interface connectors and power switch and slide
the two tabs into the two slot to latch it into place. Snap the top edge of the back panel
inside the bottom case. The back panel should now be flush to the rear of the bottom case.

Zebra G SERIES Specifications

General

Print Method	Thermal Transfer
Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Maximum Print Length	39 inches (991 mm)
Media Sensors	Reflective, Transmissive
Media Length	39"/991 mm
Programming Languages	ZPL II
Connectivity	USB, Serial, Parallel, Ethernet (depending on model)