67
Replacing Parts
Replacing the Ribbon Carriage
8/27/08 Thermal Transfer G-Series
TM
Service Manual 980618-001 A
Installation
1. With the print mechanism open, lower the ribbon carriage into place carefully inserting
the wire bundles and cables through the lower, inner frame.
2. Replace both the screws and washers the hold the ribbon carriage to the lower, inner
frame. Use a #1 Phillips screwdriver to tighten them.
3. Lower the top, inner frame over the ribbon carriage; make sure the flapper slides into its
guide tracks on the ribbon carriage.
4. Attach the links on both the left and right sides.
5. Secure the ribbon sensor cable to the bottom, inner frame using the clip.
6. Secure the print head wire bundle to the bottom, inner frame using a tie wrap. Snip off the
excess.
Replace the Main Logic circuit board, top case and bottom case.
Clean the printhead.
Reload media. Plug in power, turn on the printer and print a status report to ensure proper
function.
To Next Page
Loading...
Need help?
General
