Getting Started
Defaulting ALL Print Servers
76
P1043301-005 11/21/13
Using ZebraNet Bridge
ZebraNet Bridge may be used default the print server to factory settings. Refer to the ZebraNet
Bridge Enterprise User Guide for more detailed information.
Using a ZPL Command
Issue the ZPL command shown immediately below or refer to the ZPL II
®
Programming
Guide for ZPL II, ZBI 2, Set-Get-Do, Mirror and WML for further details.
^XA^JUN^XZ
Defaulting the ZebraNet 10/100 Print Server on the 105SL, S4M,
PAX4, and External Devices
The Test button is accessed via a small recessed hole on the back of the external ZebraNet
10/100 Print Server device (see Figure 1 on page 35). To press the
Test button, you need to
insert something small into the hole, like the end of a paperclip.
For the internal ZebraNet 10/100 Print Server device, the
Test button is located on the back of
printer.
To default the ZebraNet 10/100 Print Servers to factory settings using the Test
button, complete these steps:
1. Turn off (O) the printer.
2. With the printer turned off, press and hold the Test button on the ZebraNet 10/100 Print
Server device and turn on (
l) the printer.
3. The status indicator tells you when ZebraNet 10/100 Print Server has been reset to factory
defaults, as follows:
• If an active network cable is connected to the ZebraNet 10/100 Print Server, the status
indicator turns solid green.
• If there is not an active network cable connected to the ZebraNet 10/100 Print Server,
the status indicator flashes red.
4. Release the Test button.
For more details on status indicators, see External ZebraNet 10/100 Print Server Network
Status and Status Indicators on page 134.
Note • To download a copy of either of the guides mentioned above, visit the Zebra web site
at: www.zebra.com/manuals.
Note • You must have an active network cable connected to the external ZebraNet
10/100 Print Server device to default the device using the
Test button.
To Next Page
Loading...
Need help?
General
