Zebra Net User Manual

Getting Started
Defaulting ALL Print Servers
78
P1043301-005 11/21/13
Defaulting the Print Servers on the HC100 Printers
To default the print server to factory settings, complete these steps:
1. Press and hold Feed for two seconds.
2. Wait for the three blink sequence of the Error/Status LED.
3. Release Feed.
Defaulting the Print Servers on the 105SL, PAX4, Xi4, ZE500, and
105SLPlus Printers
To default the print server to factory settings, complete these steps:
1. From the control panel, press SETUP/EXIT two times.
2. Press PLUS (+) five times.
The control panel will read DEFAULT NET.
3. Press NEXT/SAVE to save the change.
The control panel will read PRINTER READY.
Note • Be sure to count the number of LED blinks. The three blink sequence defaults only
the print server parameters while the four blink sequence defaults all of the printer
parameters.

Zebra Net Specifications

General

Brand	Zebra
Model	Net
Category	Print Server
Language	English