Applications
64
GPS Test Information
The GPS Test only applies to WWAN devices.
• GPS Provider Enabled - Whether GPS is enabled (true) or disabled (false)
• Latitude - Current latitude position
• Longitude - Current longitude position
• Altitude - Current altitude in meters
•Bearing - Current bearing
•Speed - Speed in meters per second
• Accuracy - GPS accuracy in meters.
NOTE: Not supported on WLAN only devices.
System Test Information
Use the System Test to determine if the CPU or memory loads are too high, there are too many processes
running on the device, or storage on the device is almost full.
•CPU Load - Amount of CPU being used
• Free Physical Memory - Amount of RAM available
• Free Storage - Amount of internal Flash memory available
• Process Count - Number of processes currently running.
WLAN Test Information
If the WiFi radio is not present or disabled, skip this test. This test determines if the device’s WLAN
configuration is correct or whether there is any connection with an access point or network.
• WLAN Enabled - WLAN radio is enabled or disabled
• WLAN Status - Current status of association with the access point
• ESSID - Name of the wireless network
• BSSID - MAC address of the connected access point
• MAC Address - Device’s MAC address
• Signal - Strength of the Wi-Fi signal (in dBm)
•IP Address - IP address of the device.
WWAN Test Information
The WWAN Test only applies to WWAN devices.
• SIM State - Current state of the SIM card
•WAN Type - Data connection type
• Signal Strength - Current cellular signal strength
• Phone Number - Phone number assigned to the device
To Next Page
Loading...