Troubleshooting
112
The following example of a communications Diagnostic mode printed out. The printout displays
hexadecimal data 00h-FFh (0-255 decimal) with a unique character for each hexadecimal value displayed
above the hexadecimal data.
The blank lines between the lines of data are where serial port and Bluetooth data handling errors get
logged. The errors are:
F = Frame Error
P = Parity Error
N = Noise Error
O = Data Overrun Error
To exit the diagnostic mode and resume printing, turn OFF and then turn ON the printer. An alternate
method for exiting the diagnostic mode is to press the FEED button as many times as it takes to clear the
printer’s command buffer and print ‘Out of Diagnostic mode’ on the label.
****************************
****************************
Out of Diagnostic Mode
*
*
To Next Page
Loading...
Need help?
General
