Print Operations
73
Adjusting the Print Width
Print width must be set:
• Before you use the printer for the first time.
• Any time you change the width of the media in use.
Print width may be set by:
• The Windows printer driver or application software such as ZebraDesigner ™ .
• Controlling printer operations with ZPL programming; refer to the Print Width (
^PW) command
(consult your ZPL Programming Guide).
Replacing Supplies while Using the Printer
If media (ribbon, labels, receipts, tags, tickets, etc.) run out while printing, leave the printer power on while
reloading (data loss results if you turn off the printer). After you load a new roll of media, press the FEED
button to restart.
To Next Page
Loading...