Setup
31
Loading Roll Media (continued)
1. Cutter Models - For printers with the optional cutter module installed, thread the media through cutter’s
media slot and pull it out the front of the printer.
2. Close the printer. Press down until the cover snaps closed.
You may need a calibrate your printer for the media. The printer’s sensors need to adjust to sense the
label, the liner, and the distance between labels to operate properly. When reloading the same media
(size, vendor, and batch), you can just press the FEED (Advance) button once to prepare the media for
printing.
To Next Page
Loading...
Need help?
General
