Setup for Windows
®
OS
61
9. The values set in the Authentication PIN field will vary depending on the Bluetooth (BT) version of the
master device. If the master uses BT v2.0 or older
, enter a numeric value in this field. You will be
prompted to enter this same value on the master device to verify pairing. Security Mode 2 or 3 in
Advanced Settings should also be selected for PIN paring.
10.If the master device uses BT v2.1 or newer
, this setting has no effect. BT v2.1 and newer uses Secure
Simple Paring (SSP) which does not require the use of a PIN.
11.Clicking on the Advanced Settings button will display the Advanced Bluetooth Settings window. For
more information on Advanced Settings, refer to the Wired and Wireless Print Server Guide.
12.Click Next to continue configuring your printer.
13.The SGD commands to properly configure your printer will be displayed. Click Next to continue to the
Send Data screen.
14.On the Send Data screen, click on the Printer that you want to send the commands to or click on the
File button to save the commands to a file for reuse later.
15.To send the commands to the printer, click on the Finish button. The printer will update and then reboot.
You may disconnect the USB interface from your printer now.
16.To complete the Bluetooth pairing process, enable Bluetooth device discovery on your master device
and follow the directions provided with the master device.
To Next Page
Loading...
Need help?
General
