Maintenance
96
5. Cleaning Only — Clean the platen with the alcohol moistened swab. Clean from the center out.
Repeat this process until all of the roller surface has been cleaned. If there has been heavy adhesive
build-up or label jam, repeat with a new swab to remove residual contaminants. Adhesives and oils, for
example, may be thinned by the initial cleaning but not completely removed.
6. Discard the cleaning swabs after use - do not reuse.
7. Make sure the bearings and drive gear are on the shaft of the platen roller.
8. Align the platen with the gear to the left and lower it into the printer’s bottom frame.
9. Rotate the platen bearing latch release tabs down on the right and left sides towards the rear of the
printer and snap them into place.
10.Allow the printer to dry for one minute before closing the dispenser door, media cover or loading labels.
To Next Page
Loading...
Need help?
General
