INSTALLATION INSTRUCTIONS AND FIRST-TIME SET-UP
ZEISS Installation instructions and space requirements Axio Observer
36 431004-7244-001 12/2016
4 INSTALLATION INSTRUCTIONS AND FIRST-TIME SET-UP
4.1 Installation instructions and space requirements
The following requirements apply regarding installation of the device:
− Dimensions of Axio Observer stand (width x depth x height):
approx. 295 mm x 850 mm x max. 707 mm
− Distance of the system to the wall, at least 3 cm
It must also be ensured that the floor on which the support/table stands is subject to the least possible
vibration. Only operate the device on a hard, non-flammable surface.
The parameters described in sections Ambient conditions and Technical data must also be observed (see
page 33 and 34).
4.2 First-time set-up
Because of the complexity of the equipment and to ensure correct function, the Axio Observer
microscopes will be installed and set up for use on site by your ZEISS representative.
This includes the following services:
− Installation of the microscope, assembly and adjustment of all components (where these are not
factory-adjusted)
− Connection of cables and power supply
− Training
To Next Page
Loading...
