Zenoah GZ3500T Workshop Manual

22 – English
Safety equipment
6.8 Resistance test - stop function
1
Remove the starter, see “Dismantling the starter”.
2
Remove the cold air wire.
Fig 26
Fig 27
Fig 25
When assembling the cold air wire, make sure that the
ignition cable is tted into the slot.
Clean the contact areas and check the resistance
as follows:
Test the resistance by connecting a multimeter to
the ignition coil. Note! The power switch must be
in the “on” position to get the correct reading, see
gure 26.
The resistance must not exceed 0.5 Ohm with the
power switch in the “on” position.

Zenoah GZ3500T Specifications

General

Brand	Zenoah
Model	GZ3500T
Category	Chainsaw
Language	English