Zetor Major 80 - Checking Oil Levels in Engine; Draining Oil from Engine; Front Bonnet Opening

120
MAINTENANCE INSTRUCTIONS
NM13N107 X903 E703
FRONT BONNET OPENING
Opening the bonnet:
Unlock the bonnet by pulling the draw
bar (1) in the direction of an arrow, grip
where the arrows are and heave.
The bonnet is locked in the heaved
position by a gas-fluid prop.
Closing the bonnet:
Pull the bonnet by means of a belt, grip
where the arrows are and snap in the
downward direction so that the lock of
bonnet snaps down.
If you close the front bonnet
prudce, there can be the damage
of headlights bubs placed in the
front bonnet.
CHECKING OIL LEVELS IN ENGINE
Check daily before starting the operation
with the tractor standing horizontally.
Engine oil dipstick (1) and filling hole (2)
are placed on the rights side of the en-
gine. Unscrew the dipstick (1), wipe off
with a cloth and screw back in. When
you unscrew the dipstick again, the level
must not drop below the bottom gauge. If
necessary, refill oil by a filling hole (2).
DRAINING OIL FROM ENGINE
1. unscrew the drain plug (1), best im-
mediately after terminating the drive
or after heating the engine to work-
ing temperature
2. drain oil
3. clean the drain plug
4. screw the drain plug (1) back in