Zetor Major 80 - Rear Three-Point Linkage; Safety Principles When Working with a Three-Point Linkage

82
LINKAGES
NM13N053
REAR THREE-POINT LINKAGE
Serves for connecting carrier-mounted or
semi mounted agriculture machines and
tools with linkage points of category I. or
II. pursuant to ISO.
The categories differ based on the length
of linkage axis, which is the distance of
the centre of balls of lower linkage joints
with connected tool.
Category I.
Length of linkage axis 728 mm
∅ of holes of connecting
balls of lower draw bars
pursuant to ISO
28 mm
∅ of upper draw bar hole
25 mm
Category II.
Length of linkage axis 870 mm
∅ connecting balls holes
of lower draw bars pursu-
ant to ISO
28 mm
∅ of upper draw bar hole
25 mm
1. Upper draw bar
2. Lift rod left
3. Lift rod right
4. Limiting draw bars
5. Lower draw bars
NM13N102
SAFETY PRINCIPLES WHEN WOR-
KING WITH A THREE-POINT LINKAGE
Persons who are not charged
with work with auxiliary device of
a tractor must not stand between
a tractor and connected machin-
ery (tools) - (A).
Do not park tractor with mounted
tools in a lifted position (B).
When driving without tools it is
necessary to connect lower draw
bars (5) by springs and upper
draw bars (1) to be placed to a
flexible linkage! When transport-
ing tools it is necessary to adjust
limiting draw bars (4) of lower
draw bars so that there would be
no unwanted side movement of
tools!