121
MAINTENANCE INSTRUCTIONS
E704 E705
REPLACING FULL-CONTINUOUS
MOTOR OIL FILTER
To be done with every oil replacement in
engine. Before you screw in a new filter,
clean the sealing surface of the body (1)
and the filter (2). Grease rubber sealing
with oil, with which you will fill the engine
and tighten the filter with your hand. After
the sealing seats on the sealing of the
block, tighten the filter for a 3/4 to 1 and
1/4 of a revolution. Check the tightness
again after starting the engine.
POURING OIL TO ENGINE
Pour the set amount of motor oil engine
by filling hole (2), start the engine and al-
low it to run for 2 - 3 minutes with engine
revolutions of 750 - 800.
After stopping the engine and settling the
level recheck the amount of oil with a
dipstick (1) and check the tightness of fil-
ter, drain plug (3) and other joints.
To Next Page
Loading...
