EasyManua.ls Logo

Zetor Major 80 - All the Works Related to the Clean-Draining the Condensate from Air Collector; Ing, Greasing and Adjusting the Air System Tightness Inspection; Tractor or Articulated Machines Can Air Condition Maintenance

Zetor Major 80
157 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
133
MAINTENANCE INSTRUCTIONS
NM13N074 NM13N075 E740
DRAINING THE CONDENSATE FROM
AIR COLLECTOR
Air collector is placed on the right side of
the tractor under the cab.
Draining the condensate from air collector
to be done by deviation of venting valve
by pulling a ring.
Valve is located on the bottom part of air
collector.
AIR SYSTEM TIGHTNESS
INSPECTION
fill air collector to the maximum pres-
sure (600 20 kPa)
there must not be drop in pressure for
more than 10kPa in 10 minutes with
engine at standstill
Before driving with a trailer or a
semi-trailer, do the inspection
daily!
With pressure drop in brake sys-
tem under 450
30 kPa, a warn-
ing control lights up on the dash-
board!
AIR CONDITION MAINTENANCE
The main element of air condition
system maintenance is cleaning
air condition condenser (is placed
in front of engine radiator).
Clogged air condition condenser
decreases not only the efficiency
of cooling system but also the ef-
ficiency of engine cooling.
Open the bonnet, demount the nut (1)
and protrude the radiator to the side and
blow with compressed air or wash with
pressed water (against the direction of
tractor drive).
Slide the radiator back in and attach
properly. Mind proper conducting of hos-
es to oil radiator.

Table of Contents

Related product manuals