137
ADJUSTMENT
NM13N114
PTO SHAFT CLUTCH CONTROL LEVER
ADJUSTMENT
Free run adjustment of PTO shaft clutch
control lever (a) is done by changing the
length of control Bowden.
After releasing the locking nut (1) set the
length of Bowden by turning the nut (2).
After setting the length of Bowden, tight-
en the locking nut (1).
With adjustment hold the Bowden bolt
(3), to prevent its turning together with
adjustment nut (2).
Free run of PTO shaft clutch control
lever (a) must be 25 to 35 mm.
The track of lever between the lower lev-
er position and the point when the con-
trol force on lever increases is the free
run of PTO shaft clutch control lever.
To Next Page
Loading...
