To Next PageTo Next Page
Need help?Do you have a question about the ZIV SW3 and is the answer not in the manual?
Overview of the SW3 Gigabit/Fast Ethernet switch for large LAN deployments.
Key features and capabilities of the SW3 switch, including VLANs and network adaptability.
Details on the elements included in the SW3 package and its DIN-rail mounting suitability.
Detailed list of the SW3's switch functionalities, including QoS, VLANs, and link aggregation.
Critical safety guidelines and compliance requirements for installing the SW3.
Description of the 10/100BASE-TX ports and cable requirements for the SW3.
Details on 100BASE-FX ports using MT-RJ connectors and fiber optic cable specifications.
Details on 100BASE-FX ports using ST connectors and fiber optic cable specifications.
Description of LC ports and SFP module installation procedures for the SW3.
Configuration and electrical characteristics of the SW3's serial maintenance (SRV) port.
Connecting and interacting with the SW3 via the command-line interface (CLI).
Configuring the SW3's web server for remote management and access.
Setting general parameters like hostname, location, and access control.
Configuring administrative settings including HTTP, HTTPS, FTP, and FTPS servers.
Setting up IP addressing, subnet mask, gateway, and MAC address for the SW3.
Configuring port operating parameters, VLAN assignment, and port status.
Defining Virtual Local Area Networks (VLANs) and their operation modes on the SW3.
Setting ingress and egress bandwidth limits for individual ports on the SW3.
Configuring Quality of Service (QoS) for traffic classification and priority management.
Setting up port mirroring for monitoring network traffic on the SW3.
Configuring the Link Layer Discovery Protocol (LLDP) for network topology discovery.
Setting up the Simple Network Management Protocol (SNMP) agent and traps.
Configuring Spanning Tree Protocol (STP) and Rapid STP (RSTP) for loop prevention.
Configuring Network Time Protocol (NTP) and Simple NTP (SNTP) for time synchronization.
Managing multicast traffic using GARP/GMRP, IGMP Snooping, and static configurations.
Setting up access authentication methods via TACACS+, RADIUS, console, web, telnet, SSH, and FTP.
Implementing MAC address filtering (maclist) and 802.1x authentication for port security.
Configuring miscellaneous settings, including MAC address table aging time.
Procedures for rebooting the SW3 and updating its firmware software.
Uploading and downloading the SW3's configuration settings as files.
Downloading log files (General, Events, Authority, Security) from the SW3.
References to standards and protocols relevant to the SW3 switch.
List of acronyms and abbreviations used in the SW3 user manual.
Methods for connecting to the SW3 CLI via serial port or Telnet.
List and description of commands available for the SW3 command-line interface.
Procedures to obtain equipment status and configuration data via CLI.
Steps for installing certificates to enable secure HTTPS management on the SW3.
General