SW3
GIGABIT/FAST ETHERNET SWITCH TYPE SW3 (DIN) 16/122
USER GUIDE - M0SW3D1905Iv04 - V04 May 2019
1.5.2 Equipment safety considerations
1. There are two power-supply models:
- 48 V
DC
(10.5-72 V
DC
), isolated.
- Multirange V
DC
/V
AC
.
When using the multirange power supply the earth connection must be made
before connecting any other power-supply cable.
In the isolated 48 V
DC
model this connection is not compulsory but it is
strongly advisable.
2. ZIV will not accept responsibility for any injury to persons or third parties,
caused by the non-fulfilment of point 1.
1. The terminal contains components sensitive to static electricity, the following
must be observed when handling it:
- Personnel appointed to carry out the installation and maintenance of the
switch SW3 must be free of static electricity. An anti-static wristband and/or
heel connected to earth should be worn.
- The room housing the SW3 must be free of elements that can generate
static electricity. If the floor of the room is covered with a carpet, make sure
that it is anti-static.
2. ZIV will not accept responsibility for any damage to the equipment caused by
the non-fulfilment of point 1.
To Next Page
Loading...
Need help?
General
