SW3
GIGABIT/FAST ETHERNET SWITCH TYPE SW3 (DIN) 96/122
USER GUIDE - M0SW3D1905Iv04 - V04 May 2019
FIGURE 63 Window of characteristics of Windows
B.2 USER CONSOLE COMMANDS
After starting the session with a valid login and password, the prompt will change to
equipment /> waiting for the user to enter a command.
The commands are instructions sent to the equipment to request or change a value or to
“browse” through the tree in which the equipment parameters are organised.
The following table shows a full list of available commands with a brief description of each
one and their availability depending on the type of user starting the session, highlighting the
most useful ones.
To Next Page
Loading...
